UNAOHM
EP2500 (Rev. 0)
39
♦
PWR ON STD. Selects the standard recalled when the instrument was turned on.
♦
CH TABLE. Selects the channel format table.
8.2
EXAMPLES
WARNING:
The instrument should be in one of the normal operating modes (SPECtrum, MEAsure,
etc.). If, on the contrary, it is in a utility routine, it is better to exit from it (see section 8) and start over
again, at least until the operator has acquired sufficient experience with the instrument.
8.2.1
Buzzer ON/OFF
The instrument is equipped with a buzzer that emits a tone to confirm each time a key is pressed. This
buzzer may be engaged or disengaged as follows:
1.
Press the key
MENU (20)
to enter the main menu.
2.
Press
UP /
DOWN (4)
or until the OSD displays a small white square next to the message
CONFIGURATION, then press
↵
(21)
to confirm.
3.
Press the keys
UP /
DOWN
until the OSD displays a small white square beside the message:
BUZZER. Press
↵
(21)
to confirm.
4.
Press
BACK
twice or
MENU
.
8.2.2
Video Filter
1.
Press the key
MENU
to enter the main menu.
2.
Press
UP
or
DOWN (4)
until the OSD displays a small white square beside the VIDEO FILTER
message; this is followed by ON if the filter has been enabled or by OFF if it is disabled. To change
the status, press the confirmation key
↵
.
3.
Press
BACK
twice or
MENU
.
