9
< Guidelines for Replacement and Cleaning >
Replace or clean components if performance is reduced and/or the following symptoms
appear.
Backup inlet and outlet valves:
Replace in the event of abnormal wear, hardening, or cracking.
Cup packing:
Replace in the event of abnormal wear, hardening, or cracking.
Inlet and outlet valves:
Replace in the event of deformation, hardening, or chipping.
Bearings:
Contact the manufacturer for repair in the event of abnormal noises or
abnormal motor vibration (chattering).
Inlet valve rubber separator:
Replace in the event of deformation, wear, hardening, or cracking.
Connecting tubes: Replace in the event of deformation, wear, hardening, or cracking.
Gaskets:
Replace in the event of deformation, hardening, or cracking.
<Locations for Maintenance and Inspection>
Table 6.2 Locations for Maintenance and Inspection
Period of
operation
Inspection item
Inspection details
Method of
inspection
Every 3000
hours
Backup inlet and
outlet valves
Abnormal wear, hardening,
cracking.
Visual
inspection
Cup packing
Abnormal wear, hardening,
cracking.
Visual
inspection
Inlet and outlet
valves
Deformation, hardening, chipping.
Visual
inspection
Inlet valve rubber
separator
Deformation, wear, hardening,
cracking.
Visual
inspection
Gaskets
Deformation, hardening, cracking.
Visual
inspection
Connecting tubes
Deformation, hardening, cracking.
Visual
inspection
Bearings
Abnormal noises.
Listen
Silencer
Blocking
Visual
inspection
6.4 Replacing Consumables and Cleaning
See "Caution" (10) on p.07.
(1) The interior of the pump is extremely hot immediately after operation. After stopping
the pump, leave it for 30 minutes or more and begin replacing consumables and
cleaning only after checking that it has cooled sufficiently.
(2) To prevent ingestion of microscopic particles in the air, use a dust mask and gloves
when replacing components and cleaning.
(3) To prevent injury, wear gloves when replacing consumables.
!
Caution
