6
Installation
(1) To prevent back injuries, always use at least two people when lifting and moving the
pump.
(2) Microscopic particles resulting from wear of components are discharged from the outlet
and contaminate the room. If necessary, connect a pipe from the discharge outlet to the
outside of the building.
(3) The fine clearances used in this pump require that the following conditions be satisfied
during storage, installation, and operation.
1. Ambient temperature of 0-40°C and relative humidity of 85% or less during operation.
2. Other conditions for storage and operation
a) Level floor of sufficient strength
b) No condensation
c) Dust-free environment
d) Well ventilated
e) Environment free of corrosive or explosive gas
f) Not subject to direct sunlight
g) No danger of fire
h) Maximum ambient temperature of 40°C when
connecting the pump.
(4) Use ventilation holes, and fit a cooling fan, to reduce the temperature in the vicinity of the
pump. Ensure that the pump cooling fan inlet is not blocked. Ensure that a space of at
least 100mm is available on all sides of the pump.
Operation
(5) Touching rotating components (eg motor, main shaft, axial joints, cooling fan) while the
pump is in operation may result in injury.
(6) When the thermal protector operates, the pump will become extremely hot. Please do not
touch the pump. Touching the pump in that condition will cause burn injury. Turning off
the main power supply of the system, please contact us.
(7) Touching the motor while the pump is in operation or while it is still hot immediately after
having been switched off may result in burns.
(8) Inserting fingers or objects, or peering, into, the inlet or outlet during operation may result
in injury or malfunction.
[Continued on next page]
!
Caution
06
Use two persons
to hold here with
both hands.