Uludag G-250, Manual For Introduction, Operation And Maintenance

Page: 20 / 66

18
•
Install the cutting tool onto the machine and take necessary care for
installation.
•
Do not touch the cutting tool while the machine is running.
•
Do not operate your machine in the combustible and flammable environments.
•
Keep the machine away from the humid and damp environments.
•
Provide necessary lighting for the workplace.
•
Unplug your machine from the power source before attempting to perform any
maintainance or repair.
•
Shut your machine down after work is over.
•
Clean the sawdust on the machine regularly.
•
Keep your workplace in order. Any mess in the workplace increases the
accident risk.
•
Make use of the recommended accessories for the machine.
2.5. Noise Levels
NORMATIVE REFERENCES: Acoustic test on the machine has been
carried out under the following conditions:
RUNNING CONDITIONS OF THE MACHINE DURING TEST:
Types of saw : DRESS
Diameter of the saw : 250/300 mm
Saw speed : 2850 rpm
Cutting angle : 0° , 15° , 22.5° , 30° , 45°
The work material : Wood
Work dimensions : 30 x 30 mm
The bench on which the cutting machine is fixed : 1000 mm x 1000 mm x 900 mm ( h )
Idle Under load
Measured average noise level Lpm = 74,1 dB (A) Lpm = 74,1 dB (A)
Noise level measured at operator's place Lpm = 82,1 dB (A) Lpm = 91,3 dB (A)
Environmental correction factor K = O,9 K = O,9
The value of the correct noise level Lpc = 73,2 dB (A) Lpc = 73,2 dB (A)