Ultrawave Neon Series, Instruction Manual

Page: 9 / 28

7
Screen 4: Setting the cycle time
The Neon Series has three cycle stages:
Circ 1: this is the time that the pump will operate for, before the ultrasonics operate.
Sonic: this is the time that the ultrasonics will operate for.
Circ 2: this is the time that the pump will operate for, after the ultrasonics operate.
Total cycle time is the sum of all three individual set times.
The pump operating at the start of the cycle will flush and filter excess contaminants
before the ultrasonic cleaning process begins.
The main cleaning action occurs during the ultrasonic cleaning process.
The pump operating at the end of the cycle will flush and filter contaminants that have
been removed from the component during the cleaning process and minimise the effect
of “drag through” (contaminants resting on the com ponent), when it is removed from
the tank.
Use the “Up” and “Down” buttons to scroll through the numbers in order to increase or
decrease the time.
Each stage can be programmed from 0-80 minutes, therefore the total maximum time
a cycle can be programmed for is 240 minutes. If any of the stages are not required,
then these can be programmed to 0 minutes.
When the correct number has been selected, use the “Next” button to move to the next
character.
Once the correct cycle time has been entered, press the
“Accept” button to save the
settings.
This completes the Administrator programming of the
Neon Series.
Power down the Neon Series , using the switch at the front of the case, to exit ‘Admin’
mode. When the Neon Series is th en powered up, “Operation” mode will be in use.