3
Quick guide
Place the
Neon Series
in its final working position.
Fill the tank with fluid until it overflows into the overflow-weir. Fill the weir to at least
half way before use, but ensure that it is not completely full.
When filling the
Neon Series
prior to its first use or after a complete system drain, it
may be necessary to top up the weir after the pump first runs, to ensure there is fluid
in the system.
Add the required dose of detergent (see page 16).
Switch on the machine via the switch at the front of the
Neon Series
case.
To operate the
Neon Series
, please refer to the appropriate instructions on the
following pages.
Change the cleaning fluid at regular intervals. Your cleaning process will determine how
often the fluid needs changing – the more soiled your items, the more often you will
need to change the fluid.
The pump & filter system is supplied with filter cartridges that must be routinely
inspected and replaced if there are any signs of reduced liquid flow or the visible state
of the filter cartridge deems it necessary (see page 14).
REMEMBER
-
Always ensure the fluid is above the level sensor when in operation.
-
Do not put excessively hot water into the tank.
-
Always use the basket supplied.
-
Never expose hands or other body parts to cleaning solutions.
-
Contact Ultrawave before using any solutions, detergents or chemicals which are
not specifically approved by Ultrawave.
-
Never breathe the fumes from strong solutions.
Once the cleaning cycle has finished, remove the cleaned items and rinse them in clean
water.
Subjecting the ultrasonic cleaning system to improper treatment or misuse will
invalidate the warranty.
