Ultrawave Hygea 2850VM, Operator'S Instruction Manual

Page: 4 / 40

3
Safety instructions
Connect to a 220-240 VAC fully earthed supply via a 3pin plug.
It can be dangerous to operate an ultrasonic bath without an earth connected.
The mains plug is fitted with a 5A fuse. NEVER FIT A FUSE OF A HIGHER RATING.
Ensure that excess mains cable is stored neatly.
When the temperature is set to 54°C or above, the
Hygea 2850VM
will become hot
and care should be taken when touching the case.
A risk assessment should be conducted if the temperature is set to 54°C or above
–
see BS EN ISO 13732-1:2008 for full details
General use
Ensure that the bath contains liquid before you switch it on.
Always fill with cold water. This will ensure that the
Hygea 2850VM
always runs its
automatic de-gas cycle (see pg 27 for the importance of degassing).
Always use a basket or instrument cassette and basket carrier to support items to be
cleaned.
Not doing so may damage the bath and invalidate your warranty.
Do not place fingers or other parts of the body in the bath.
For best cleaning results use a detergent, at a suitable dose, recommended for use in
ultrasonic cleaning baths. Never use toxic, flammable, acidic, caustic or corrosive
solutions in the bath.
Refer to the
Hygea 2850VM Operator Instructions manual for full guidance on the
correct use of the bath.
The user should familiarise themselves with this
Operator Instructions manual before
operating the equipment and should apply to Ultrawave or its agent for advice on
cleaning techniques or detergents.
Ultrawave will not be responsible for damage or injury caused by incorrect use of the
equipment.