35
KRMU000003
REV A - 07/20/01
VCR-B SIGNALS
The KR4008EN VCR has two operational settings: VCR-A and VCR-B. Both signals are
available so that you may separately control two VCRs that are placed closely together. The
remote control for this VCR will only send VCR-A signals. By setting the KR4008EN to
respond to VCR-B signals, you will NOT be able to use the remote control unit. Other remotes
are capable of sending both VCR-A and VCR-B signals.
To program
the
KR4008EN
and remote
to VCR-B
Make sure that the KR4008EN is plugged in but turned OFF.
On the VCR front, press REC SPEED and REW at the same
time. To confirm that the VCR responds to VCR-B signals,
b
appears on the front panel display.
To reprogram
the
KR4008EN
and remote
to VCR-A
Make sure that the KR4008EN is plugged in but turned OFF.
On the VCR front, press SP/EP and FF at the same time.
To confirm that the VCR responds to VCR-A signals,
A
appears on the front panel display.
LOCK MODE
The lock mode prevents others from using your VCR.
To lock the VCR:
1. Press and hold down DISPLAY on the remote control for
approximately 8 seconds. LOC will display on the front
panel. When the lock feature is in use, LOC display will
reappear when you press any of the buttons.
2. To cancel the lock, press and hold down DISPLAY for 8
seconds. The LOC display will reappear when DISPLAY
is pressed. When you hold down this button, it will go out
to show the lock is cancelled.
IMPORTANT:
You can lock the VCR with the
power off, even if the VCR is standing by for a
programmed recording. If you lock the VCR with no
cassette in it, the VCR will not accept a cassette.