5
4. Locate the following parts that are taped to or enclosed in the
housing: two black plastic plates, a nylon washer, and three
hexagonal screws of varying lengths for camera mounting;
two hexagonal screws with two metal washers; and two
Phillips panhead screws with nylon washers and rubber
gaskets. Set these parts aside for later use.
5. Remove the standard silver mounting plate by unscrewing
the two Phillips panhead screws located at the rear. Then
replace this unit with the optional mounting plate with built-in
heater. Make sure that the heater plate is secured to the
shelf that extends from the rear of the housing unit.
(See
Figures 4 & 5)
6. Connect the external
power supply
(not
included)
to the circuit
board. The
recommended power
supply is 24 VAC, 50 VA.
(See Figure 6)
7. To mount your camera,
consult the section
Camera Mounting for
HEG Series Housings on
page 8. Begin with step
5. Then see UL-WB+BJ
& UL-WBM Wall Bracket
Mounting on page 11.
FIGURE 5
FIGURE 6
