2
SECTION 2
HOUSING INSTALLATION INSTRUCTIONS
2.1
HEG14-BK BLOWER KIT INSTALLATION
(without heater)
This section contains comprehensive instructions for installing
the blower kit into the HEG14 and HEG14-01 camera housing. If
you are also installing the heater, please skip to page 6 for
comprehensive instructions. The blower kit is available in a
preassembled package with a housing, heater kit, and sunshield
under model HEG14-03.
1. If applicable, remove the sunshield by snapping it off the
main housing unit.
2. Remove the three Phillips panhead screws located on the
rear of the housing unit and loosen the set screws on either
side of the external mounting plate. Retain the screws and
their black rubber gaskets, which were left in the holes on the
rear of the housing.
(See Figure 1)
3. By sliding the housing shell away from the rear portion of the
unit, separate the housing into two sections. It may be
necessary to unscrew the ground wire connection on the
silver camera mounting plate. However, be careful not to
disconnect the end of the ground cable that is attached to the
housing shell.
(See Figure 1)
4. Locate the following parts that are taped to or enclosed in the
housing: two black plastic plates, a nylon washer, and three
hexagonal screws of varying lengths for camera mounting;
two hexagonal screws with two metal washers; and two
Phillips panhead screws with nylon washers and rubber
gaskets. Set these parts aside for later use.
FIGURE 1
