Owner's manual
ULTRAFLEX
page 18
of 36-
POWER A MK2
E
NG
L
ISH
The DOCKING mode allows the user to reduce the maximum engine speed without reducing the lever
angular travel.
The DOCKING mode allows a higher sensitivity on throttle, therefore it is suitable for docking.
To enable this mode the following conditions must be met:
- The station must be enabled.
- HIGH-IDLE and TROLL modes must be off.
- There must be no failures that could prevent this mode from being enabled.
To enable the DOCKING mode, keep key SYNC
pressed; the mode will be enabled when the key is
released.
The proper red LED will light up indicating that the
DOCKING mode is on.
In the engine acceleration curve, the maximum
engine speed is set as half of the normal speed.
To disable the DOCKING mode, press the proper
key on the user interface for a few seconds: the
DOCKING red LED will switch off.
In a twin-engine system, the DOCKING mode can be enabled on one engine
only. In this case the DOCKING red LED will blink.
The DOCKING mode is disabled when changing the control station.
2.4.5 Docking mode
WARNING
