Quick View Programming
* See the following pages for more detailed programming instructions.
Menu 1 - Press Lock
1 Flash
2 Flashes
3 Flashes
1 Ignition Lock
Enabled
Lock Only
Disabled
2 Siren Chirp
Type 1
Type 2
All Chirps
3 Lock&Unlock Options
Double Unlock
3 second
.75 second
4 Unlock/Disarm
125ms
750ms
5. Passive Locks
Enable
Disable
6. Shock Sensor
Disable
Enable
7. Passive Arming
Type 1
Type 2
Disable
8. Auxiliary Outputs
Type 1
Type 2
Disable
Menu 2 -Press Unlock
1 Flash
2 Flashes
3 Flashes
1 Secure Service Mode
15 seconds
5 seconds
2 Park Light Output
30 seconds
(-) Park Light
Light Flash
3 Horn Timing
5ms
50ms
10ms
4 N/A
5 Siren/ Horn
Horn Output
Siren Output
5 Reservation Mode
Manual
Auto Reservation
Menu 3 -Press Start
1 Flash
2 Flashes
3 Flashes
1 Lock/ Unlock Type
Type 1
Type 2
Normal
2 Gas/ Diesel
Negative
15 second
Gas/ Positive
3 Rearm Output
Type 1
Type 2
Rearm
4 Run Time
4 Min
45 Min
15 Min
5 Crank Time
10 seconds
3 seconds
5 seconds
6 Starter Disable/GWR
Active
Passive
GWR
7 Safety Start Mode
Press twice
Press once
8 Programmable Input
(+) Instant Start
(+) Disconnect
Menu 4 -Press #
1 Flash
2 Flashes
3 Flashes
1 Low Idle Learn
Low Idle Learn
2 Adjust For Over Crank
Reduced by 10%
3 Adjust For under Crank
Increased by 10%
**Bold type indicates settings that are Factory Default.
Page 15
REMOTE VEHICLE STARTER
INSTALLATION MANUAL
System Reset
The system reset will clear any changes made to the Program Menu’s as well as the
Tach setting. When the system reset is complete the system must be Tach learned
before the remote starter will operate.
1)
Turn the ignition key from “Off” to “On” 3 times,
ON-OFF-ON-OFF-ON
within three
seconds
.
(Leave the key in the
ON
position)
2)
Press and release the
Program Button
located on the antenna. The park lights will
turn on and the siren will chirp one time.
3)
Then press and hold the
Program Button
until the park lights flash and the siren
will chirp 3 times slowly to confirm system reset.
System is now reset to factory defaults
.
Note:
System Reset
does not
delete the transmitter codes from memory.
