Page 8
INSTALLATION MANUAL
REMOTE VEHICLE STARTER
14 Pin Connector
Continued From Previous Page
1-Green
Door Lock Door Lock Output - Programmable
Menu 1
2-Red
12vlt Output Output For Door Lock Module Only!
3-Blue
Door Unlock Door Unlock Output - Programmable
Menu 1
4-Pink
2nd Unlock Output when button #2 is pressed twice.
*
The centre pin of the keyless entry harness is not to be used for anything
besides plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.
3 Pin Connector Red
11-Blue/White
Tach
A/C Tach Signal Input. Used to detect when the
vehicle has started. This wire is connected to the
vehicles coil, fuel injector or crank sensor wire.
12-Blue
Glow Plug
Diesel Glow plug input, detects both 12volt and
negative glow plug signals. Programmable input.
13-White
Park Lights
+10amp park light output. At light harness 0volts when
Park lights are off, 12volts when park lights are on.
14-Black/
Park Brake
Input to detect Park Brake Switch. Connect to wire at
White
the switch that switches to (-) when the switch is applied.
White/Green
LED Output
Pulsed negative output for LED activation.
Black
Dome Light
Negative Output For Dome Light Supervision.
White/Blue
Siren
Positive Output For Siren.
Red
Trunk Pin
Negative Input For Trunk Pin Switch.
4 Pin Connector Square
3 Pin Connector White
Green*
Auxiliary 1 Programmable Output. Press buttons #1 and #3
Pink
Auxiliary 2 Programmable Output. Press buttons #2 and #3
Blue
(+) Disconnect (+) Disconnect Or Instant Start Trigger.
*The default setting of the green wire is Negative Horn Output.
2 Pin Connector White
If the Temperature Sensor is installed the Cold Start Mode will operate by
monitoring temperate. If the sensor is not installed the Cold Start Mode will
function as Timer Mode. The temperature sensor can be installed under the
hood strapped to the radiator hose to monitor coolant temperature or left
mounted under the dash to monitor ambient air temperature.
