PAGE 13
INSTALL GUIDE
Tach Learning the remote starter is one of the most important steps in
the installation process. Do not tach learn vehicle while the engine is
in high idle. To ensure the best possible tach setting, ensure that the
vehicle is at low idle/ normal operating RPM. Vehicles such as Toyota
and Honda may idle much higher when the engine is warm compared
to starting the vehicle when the engine is cold. The Quick Learn
feature may be used to tach learn the vehicle again but at a normal
engine RPM.
BRAKE
BRAKE
1)
Start the vehicle and leave it running with the ignition key
until the engine idles down.
2)
Press and hold the brake pedal.
3)
Press and release, then press and hold the Program Button.
4)
The park lights will flash to confirm Quick Learn Tach*.
Important Tach Notes
Quick Learn Tach
(with Blue/White connected only)
Quick Learn Tach is designed to re-learn the remote starters tach
setting while the vehicle is at normal idle RPM. Vehicles such as
Toyota and Honda will run at a very high idle for a number of minutes
when first started. If tach learned when the vehicle is at high Idle, then
remote started when the vehicle is cold. The engine does not
increase to the RPM that is was learned at. The following steps can
be used to learn tach at a more suitable idle:
NOTE:
The System MUST be “Tach Learn” before the “Quick Learn”
feature will function.
TIP
:
“Manual Low Idle Learn”. While in “Auto Tach Learn” mode,
firmly apply the park brake and press the brake pedal. Place the
transmission into reverse gear this will lower the Engine Idle.
