The 2000DX is supplied ready to be hard wired to a building power system. Terminal blocks
are supplies in the electronics cover of the Fan Housing to connect power to. To connect
the power wiring, remove the four sheet metal screws holding on the electronics cover.
Be careful when removing the cover on the Fan Housing, as the control knob is in some
configurations affixed to the cover. Wire the terminal blocks as shown in the illustrations.
Please see the Diagrams for additional reference.
Always wait at least 60 seconds before turning power back on.
Fan Housing Wiring Arrangement
The Fan Housing should be wired to a 240 VAC, single phase, 50 / 60 Hz dedicated circuit
with a maximum service rating of 15 Amps.
