MD40
PRODUCT INSTRUCTION MANUAL
MD40
Page 19 of 56
Author: N.Carapiet | Revision: 1.1
Replacing Motor Assembly after bakeout:
1.
Place the belt onto the drive thimble.
2.
Hook the motor pulley into the drive belt and then locate motor assembly into position.
3.
Replace and tighten M5 Cap Head Screw.
4.
Re-install belt cover.
Note, If any switch options are selected care must be taken when removing and re-fitting the
motor. Make sure the thimble is rotated away from the central position. Otherwise the sensor
flag will interfere with the home sensor and prevent the motor from being removed or re-fitted
and may damage the switches.
Home Sensor
Home Sensor Flag
