MD40
PRODUCT INSTRUCTION MANUAL
MD40
Page 10 of 56
Author: N.Carapiet | Revision: 1.1
How to re-install the Drive Thimble:
7.
Push Drive Thimble over the Flange Assembly (take care when re-coupling the magnets
–
the magnetic coupling may cause a sudden movement)
8.
Replace Bearing Cap
9.
Insert and tighten 3 x M3 Grub Screws
10.
Replace Dual Shaft End Cap (ensure that the drive pin locates in the drive slot)
11.
Insert and tighten 3 x M3 Grub Screws
2.1.5 Bakeout procedure
The manual drives can be baked to 250
o
C without the need to remove any components.
In the case of the dual shaft version, please refer to
the manufacturer’s instructions relating to any
motors/pulleys you may have installed onto the MagiDrive.
End Cap
3 x M2.5 Grub Screws
Bearing Cap
Drive Thimble
3 x M2.5 Grub Screws
