4
Programming
From a DCC center the decoder can be programmed by keys and solenoid
instruction or by using CV programming.
With key programming not all items can be used.
Item
Key Programming
CV-Programming
Data format
x
x
Switching Addresses
1
2
Stop positions
2
4
Switching time
x
x
Relay Switching time
-
x
Selection whether the servo is always to be
switched on or only during servo movement
- x
Programming by Key and Solenoid Command
The desired servos should be connected to the outputs that are to be programmed
and should be attached, since the servo decoder acknowledges the setting of the
servo parameters during programming with a movement of the respective servo.
1. Activating Programming Mode
Press the key on the decoder and keep it pressed. The control LED blinks.
2. Selecting Data Format
The LED blinks alternately at flashing rate A and flashing rate B for 5 seconds in
each case.
Meaning:
Blinking rate A = __ __ __
= selection DCC format
Blinking rate B = _ _ _ _ _ _
= selection Motorola format
