Ugin e.ON sinter fast, Instructions For Use Manual

Page: 16 / 27

Instructions for use (rev 011221) e.ON sinter fast +
UGIN DENTAIRE 15
6.6. PROGRAMS
Four programs are pre-recorded in the furnace: No. 1 is a conventional cycle, No. 2 and No. 3 are a shorts
programs, and No. 40 is the decontamination program. Programs No. 1, 2 and 3 are given as an example.
CAUTION: comply with the recommendations of the manufacturer of the zirconia used to verify
compatibility with the perform of a short program and the maximum number of elements in
short cycle.
Follow its instructions for programming within the technical limits of the e.ON sinter fast + (the
value of the heating rate must be less than 94°C /min up to 1000°C).
Check with the cycle diagram that the furnace follows the requested temperature curve.
6.6.1. PROGRAM PRE-RECORDERED No. 1 (conventional cycle)
C01 50,0 C06 900,0 C11 0,0 C16 0,0
T01 50 T06 -121 T11 0 T16 0
C02 300,0 C07 0,0 C12 0,0 C17 0,0
T02 70 T07 0 T12 0 T17 0
C03 1000,0 C08 0,0 C13 0,0 C18 0,0
T03 150 T08 0 T13 0 T18 0
C04 1530,0 C09 0,0 C14 0,0 C19 0,0
T04 120 T09 0 T14 0 T19 0
C05 1530,0 C10 0,0 C15 0,0 C20 0,0
T05 70 T10 0 T15 0 T20 0
6.6.2. PROGRAM PRE-RECORDERED No. 2 (short cycle, for up to 5 single unit)
C01 50,0 C06 1530,0 C11 0,0 C16 0,0
T01 15 T06 20 T11 0 T16 0
C02 300,0 C07 900,0 C12 0,0 C17 0,0
T02 30 T07 -121 T12 0 T17 0
C03 1200,0 C08 0,0 C13 0,0 C18 0,0
T03 15 T08 0 T13 0 T18 0
C04 1400,0 C09 0,0 C14 0,0 C19 0,0
T04 17 T09 0 T14 0 T19 0
C05 1530,0 C10 0,0 C15 0,0 C20 0,0
T05 60 T10 0 T15 0 T20 0