Ugin e.ON sinter fast, Instructions For Use Manual

Page: 11 / 27

Instructions for use (rev 011221) e.ON sinter fast +
UGIN DENTAIRE 10
5. START-UP
After checking that the mains voltage matches that noted on the rating plate, plug the cord into a standard
20A socket with a ground terminal, or which is recommended, directly on a minimum 20A line of the
electrical panel .
NOTE: If not used for a long time, switch off the power supply.
- Activate the breaker (ON/OFF) at the back of furnace.
-
Following power up, the initialization interface
appears on the screen. The main screen
automatically appears as follows:
menu “Working
interface”.
Note:
Temperature unit: degrees Celsius (°C)
Unit of time: minutes (M)
-
-
Lower the platform : press the "down arrow" key on the touch screen
-
Remove the cushioning foam pad placed on the platform and inside the heating chamber.
-
Remove the dust with a vacuum cleaner (do not use compressed air).
-
Visually inspect the heating elements.
- First time use, press the “arrow key upward” and “arrow key downward” on touch screen.
- Check the alignment of the platform with the base of the chamber: movements must be made without
friction.
-
Do not place any objects behind the platform that could obstruct its movement or fall, which could
damage the furnace or cause a failure.
- Place the support on the platforrm.
DO NOT PLACE ANY OBJECT WHICH MAY BLOCK THE ASCENT AND DESCENT OF THE PLATFORM
IMPORTANT
▪
Carry out a decontamination program as a precautionary measure before the first use of the
furnace
: start the pre-recorded program number 40 (see chapter 6.6).
▪
For the first time or after a long time without use, need to preheat the muffle furnace to
eliminate condensation and avoid fractures of the refractory material: launch a
decontamination program (pre-recorded program number 40).
6. USE AND CONFIGURATION
6.1. WORKING INTERFACE
Following power up, the initialization interface appears on the screen.
The main screen automatically appears: menu
“Working interface”.