Instructions for use (rev 011221)
e.ON sinter fast +
UGIN DENTAIRE
11
6.2.
CONTROL KEYS
PICTURES
KEYS
DESCRIPTION
Start cycle
(RUN)
The selected program is started.
Pause
(HOLD)
In running state, the program will be in a suspended state,
the temperature remains constant.
Stop
(STOP)
Under operating state or suspended state, the program will
end.
Ascent platform
(ARROW KEY
UPWARD)
Press this key, the platform will rise, press again, the platform
will stop at the desired level.
Descent platform
(ARROW KEY
DOWNWARD)
Press the key, the platform go down, press again, the
platform will stop at the desired level.
NOTE: if the furnace temperature is above 300°C, it is not
possible to start a cycle (risk of damaging the insulation
materials). Then, press descent platform key (ARROW KEY
DOWNWARD): an alert message appears in the status bar
(bottom of the screen).
Menu
(MENU or logo
Microsoft)
Pull-down menu appears, as shown below:
Working interface
Parameters current cycle display.
Real-time curve
Display of the cycle curve (temperature/time).
Program editor
Program settings.
Parameter setting
Software settings. Only access with technician code
(reserved for technicians customer’s service UGIN
DENTAIRE).
Language selection
Available languages: English, French, Spanish and Italian.
Date setting
Setting the date, time and day of the week.
Current program
Number of the recorded program that will start or in progress
Operation code
This code is a follow-up of the cycle progress. It is displayed
according to the programmed steps (operation code No. 1:
1
st
step; operation code No. 2: 2
nd
step; etc.).
When starting the cycle, check that the operation code
displayed is at 1.
Summary of Contents for e.ON sinter fast
Page 1: ...INSTRUCTIONS FOR USE Sintering furnace R v 011221...
Page 27: ......
