UFO Unidrive CC9, Product User Manual

Page: 2 / 16

Thank you for purchasing this low voltage UFO Constant Current Driver.
The CC9 is a compact 350mA output constant current multi-function driver designed to drive
UFO constant current LED fittings up to 16W. Constant voltage LEDs cannot be connected to this
driver. Please refer to the specific section within this manual for wiring/connection guidance.
IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT,
ITS COMPONENT PARTS AND THE HAZARDS INVOLVED.
ELECTRICAL WIRING AND CONNECTION MUST BE CARRIED OUT BY A SUITABLY QUALIFIED
PERSON OBSERVING ALL LOCAL AND STATUTORY ELECTRICAL AND SAFETY REGULATIONS.
WARNING
This driver is designed to work with constant current LED fittings operating on a 350mA output .
Connecting this driver to any other LED devices may result in catastrophic failure of the LED
device and/or the CC9 driver. Always check the input current and voltage of the LED devices to
ensure compatibility prior to powering up the system.
Never hot swap LED fittings. When adding or removing LED fittings always power
down the system first.
WARNING
This driver is designed to work on a DC input voltage of 12-48V ONLY. The DC PSU supplying this
driver must have an output capability sufficient to power up the driver and maintain the output
load.
This CC9 driver is suitable for indoor/dry areas and must not be installed in damp or wet
conditions.
INTRODUCTION
UNIDRIVE CC
9
USER GUIDE
2