Device
Func
ti
on
A
Power input jack socket (2.5mm centre posi
ti
ve). DC input voltage 12V to 48V
dependent on number of LED
fi
tti
ngs connected
B
DMX input/output screw terminals. Data posi
ti
ve, data nega
ti
ve and ground.
Occupies two DMX channels – Channel 1
LED dimming, Channel 2 LED ON/OFF.
Use for DMX control or Master Slave link to other CC9 drivers
C
Func
ti
on LED – indicates signal and control presence
D
Power and fault LED – indicates power input and overcurrent, short circuit and
over temperature faults (
fl
ashing)
E
Func
ti
on DIP switch – sets di
ff
erent func
ti
ons (manual, DMX, sensor input etc.)
and also addressing for DMX. Switch down for ON up for OFF
F
0
10V input screw terminals. Posi
ti
ve and nega
ti
ve current source (external
receiving voltage) 0
10V dimming voltage input (0 to 100%)
G
Manual (current sink) dimming screw terminals – 10V on screw terminals adjusted
by external electronic poten
ti
ometer. Normally linked out when not in use
H
Constant current screw terminal output LED + and common ground
J
FADE IN poten
ti
ometer. Adjusts the fade in
ti
me for sensor opera
ti
on between 1
and 12 seconds
K
DELAY poten
ti
ometer. Adjusts the on
ti
me for sensor opera
ti
on (between fade in
and fade out) from 1 sec to approximately 5 minutes
L
FADE OUT poten
ti
ometer. Adjusts the fade out
ti
me for sensor opera
ti
on between
1 and 12 seconds
M
Sensor input – one normally open (N/O – goes open circuit to trigger FADE IN)
one normally closed (N/C – goes closed circuit to trigger FADE IN)
FUNCTIONAL
INFORMATION
UNIDRIVE
CC
9
USER
GUIDE
4
Summary of Contents for Unidrive CC9
Page 14: ...NOTES UNIDRIVE CC9 USER GUIDE 14...
Page 15: ...NOTES 15 UFO LIGHTING...