INSTALLATION
SIRIUS USER GUIDE
6
CONNECTION
-
FOR MANUAL OPERATION
There are 2 connections required – the fibre port and the mains supply cable. The fibre port
should be connected first. Connect and secure the fibre optic connector into the collar and
secure using the M5 locking screw.
Connect the PSU to the DC input jack socket on the light source, and connect the IEC plug to the
PSU. Plug the mains plug into the electrical supply socket. Switch on power the led Indicator
will illuminate and the light source is ready for use. If no light is produced consult the
TROUBLESHOOTING section of this user guide.
CONNECTION
-
FOR DMX OPERATION
There are 3 connections required – the fibre port, the mains supply cable and the DMX cables.
The fibre port should be connected first. Connect and secure the fibre optic connector into the
aluminium collar and secure using the M5 locking screw.
Connect the PSU to the DC input jack socket on the light source, and connect the IEC plug to the
PSU. Plug the mains plug into the electrical supply socket. Switch on power. The led Indicator
will illuminate and the light source is ready for use. If no light is produced consult the
TROUBLESHOOTING section of this user guide.
Connect to the 3 pin XLR sockets on the side panel as detailed below using an approved DMX
cable.
Only approved DMX cables should be used.
Always “daisy chain” a DMX universe. Never use a T joint in a DMX universe unless using an
approved interface.
It is always recommended that the last illuminator output in the DMX universe or cable run be
terminated with a 120 ohm resistor across DMX+ and DMX-.
