OPERATION
SIRIUS USER GUIDE
14
0-10
V OPERATION
STANDARD WHITE LIGHT DIMMING
For 0-10V dimming operation dip switch 10 must be on, the manual dimming control on the
side panel must be turned to minimum (fully counter clockwise), and the RJ45 plug must be
plugged into the right hand (Dimming) RJ45 socket on the side panel.
The light source can be dimmed from 0 (0 Volts DC) to 100% (10V DC) with a receiving 0-10V
signal.
EMERGENCY WHITE LIGHT DIMMING
For 0-10V dimming operation dip switch 10 must be on, the manual dimming control on the
side panel must be turned to minimum (fully counter clockwise), and the RJ45 plug must be
plugged into the right hand RJ45 socket on the side panel.
The light source can be dimmed with a receiving 0-10V signal as detailed in the table below.
Function
Value (DC)
Description
Maximum Light
0V
Maximum light output - default control
emergency mains Failure
Minimum Light
1V
Minimum light output - normal
dimming control
Maximum Light
10V
Maximum light output - normal
dimming control
Note:
In this configuration when the mains supply to the 0-10V controller fails, the light source
will illuminate fully as an emergency light.
DECORATIVE COLOUR OR TWINKLE WHEEL CONTROL
-
NO SENSOR
For 0-10v wheel control DIP switch 10 must be ON, and the RJ45 plug must be plugged into the
left hand (0-10V motor control) RJ45 socket on the side panel.
The light source decorative wheel can be controlled with a receiving 0-10V signal from stop at 0V
to 7.5rpm at 10V
Note:
For this configuration the twinkle wheel is solid without a cut out segment.
