UFO Luna CM, Product User Manual

Page: 13 / 16

ADDITIONAL PROCEDURES FOR DECORATIVE MANUAL MOTOR MODELS
Note:
Please complete relevant troubleshooting procedures before returning the unit to us for
further investigation.
ADDITIONAL PROCEDURES FOR DECORATIVE DMX MODELS
ADDITIONAL PROCEDURES FOR DECORATIVE
0-10
V MODELS
Problem Possible Cause(s) Remedy
Decora ti ve
wheel not
turning
Motor control at minimum Adjust motor control at rear
Dip switch no 10 not switched
on
Remove cover and switch dip
switch 10 to on
Driver circuit or motor failure Replace illuminator
Problem Possible Cause(s) Remedy
Not responding
to DMX control
Dip switch no 10 is switched on
Remove cover and set dip switch 10 to
o ff
DMX address not correctly set Remove cover and set correct address
No DMX signal from controller Check DMX controller for correct se tti ng
Wiring fault on DMX cables Check cables and repair as required
Driver circuit failure Replace Light Source
Problem Possible Cause(s) Remedy
No 0 ­ 10V signal
present
Dip switch no 10 is switched
o ff
Remove cover and switch dip
switch no 10 to on
No 0 ­ 10v signal at illuminator
due to cable or controller fault
Check input to illuminator using
a DMM set to correct range ­
rec ti fy cable / controller fault
TROUBLESHOOTING
13
UFO LIGHTING