When the micro-fibre cloth becomes
very wet or dirty, replace it with a clean
and dry one.
The micro-fibre cloth becomes very hot
when using the steam mop. Use caution
when replacing.
In order to thoroughly sanitize an area of
your floor, wait 60 seconds for the unit
to heat up, then mop the selected area
with a short forward and backward motion for
about 15 seconds.
8
After use, slide the
calor
switch to the
off
position
and wait until no steam is emitted from the cleaning
head.
9
Empty the water tank and unplug the unit from the
outlet.
After use / Cleaning and maintenance
After use
●
When finished steam cleaning, make sure that the
calor
switch is in the
off
position, then unplug the unit
from the outlet.
●
Pour out water from the water tank.
●
The micro-fibre cloths are machine washable
(at max. 60°C).
If the cloths are very dirty, before
washing soak them in warm water with
some detergent or stain remover.
●
Thoroughly dry the cloths before storage.
Replacing the water softening filter
The water softening filter helps to remove minerals
from water which may impact the performance of your
steam mop. How often the filter should be replaced
depends on how hard your water is and how often you
use the unit. We suggest that you replace the water
softening filter every 6 months or so.
The degree of filter contamination may
impact the performance of your steam
mop.
C
Before replacing the filter, unplug the
unit from the outlet.
1
Remove the water tank (see the “Steam function”
section
3
).
2
Pull the filter up and remove it from the unit.
3
Replace the used filter with a new one. Press the
new filter so that it touches the unit base closely.
4
Refit the water tank.
Cleaning the electrobrush
Over time pieces of threads, strings, hair,
fabrics, etc accumulate on the roller of
the electrobrush. They impact the
sweeping performance and therefore the roller
should be periodically cleaned (at least once
monthly).
Before cleaning the electrobrush, unplug
the unit from the outlet.
The roller of the electrobrush may be removed for
thorough cleaning.
1
Turn the roller lock located at the bottom of the
cleaning head to the
position.
2
Remove the roller lock and the roller from the unit.
3
Using scissors or a sharp knife, carefully clean the
roller of the electrobrush. Using scissors or a sharp
knife, cut hair or threads rolled around the roller.
Be careful no to damage the bristle and
the roller of the electrobrush.
4
When cleaned, refit the roller.
5
Refit the roller lock and turn it to the position.
The roller is now locked.
Disassembling the holder and storing
the unit
The holder is detachable for easy storage of the unit in
low cabinets.
1
Twist the upper cord wrap downwards.
2
Unwind the cord from the wraps.
3
Press the tube lock and slide out the tube with the
holder upwards.
G
E
