M a i n t e n a n c e
Service
WARNING!
Repair and service of this instrument is to be performed by qualified
personnel only. Improper repair or service could result in physical
degradation of the meter. This could alter the protection from electrical
shock and personal injury this meter provides to the operator. Perform
only those maintenance tasks that you are qualified to do.
These guidelines will help you attain long and reliable service from
your instrument:
1. Keep your meter dry. If it gets wet, wipe it dry immediately.
2. Whenever pra c t i cal, keep the instrument away from dust and
dirt, which can cause premature wear and collect on
internal components.
3. Although your instrument is built to withstand the rigors of daily use,
it can be damaged by severe impacts. Use reasonable caution when
using and storing the instrument.
Cleaning and Decontamination
Periodically clean your meter’s case using a damp cloth.
DO NOT
use
abrasives, cleaning solvents or strong detergents, as they may damage
the finish or affect the reliability of the structural components.
Probe tips can be cleaned with an abrasive, adequate to remove
build-up, to ensure good electrical contact.
DANGER!
DO NOT
submerge this instrument in liquid! Liquids may enter this
instrument during cleaning and leak out in subsequent use, exposing
the user to dangerous voltage during measurement.
Repair
This unit contains no user serviceable parts. In the event your
instrument is physically damaged or does not function properly,
please return the instrument to UEi following the warranty and
service instructions.
S p e c i f i c a t i o n s
Operating range
ECT600A-MAN
P. 3
Vo l t a g e
12 to 600 Volts DC or AC (at 50 - 60 Hz)
M aximum voltage input 700 V DC or AC (ground to phase)
Single probe sensitivity = 100 - 700 V AC (audio only)
C o n t i n u i ty
Audio tone from 0 to 900 K
Ω
(Requires changed instrument)
Output to unit under test: Approximately 2 µA at 1.5 V DC
Charging time: =/>5 sec @ =/> 100 and =/< 700 V AC
Recommended time between charges: 30 min @ no-load
Continuos operation time between charges: 60 + sec*
* O p e rating time is dependent upon time since last charge
O p e rating tempera t u r e
14 - 131˚F (-10 - 55˚C) @ =/<85% RH
and humidity
Power consumption
< 250 mA (Continuos)
D i s p l a y
Ve r t i cal panel of light emmiting diode LED s
Size (excluding
2 - 1/6” (W) x 9-1/8” (H) x 1-3/4” (D)
detachable test lead)
( 53 mm x 230 mm x 45 mm)
We i g h t
.46 lbs. (210 Gra m s )
Power supply
Rechargeable capacitor - draws power from source tested
A c c u ra cy
This instrument is not intended for precise measurement
L ED indicators will light when voltage approaches an
i n d i cated value, and remain lit when higher voltage is
a p p l i e d
* 2 40 / 2 08 volt cross sensitivity: The 240 volt LED begins to
illuminate at about 210 volts - Although some 208 volt
s o u rces may illuminate the 240 volt LED, it typically does
not fully illuminate until it reaches approximately 215 volts.
R e s p o n s e
1 sec. max i m u m
Protection class
IP 50
Over-voltage ca t e g o ry
CAT III, 700 volts to ground
Pollution degree
2
C a l i b ration cy c l e
Annual certification is recommended
