DIGITAL TERRESTRIAL TERMINAL
USER MANUAL
NOTE: In the event that only one DTT but more than one TV set is used
domestically, the same channel will be viewed on all sets.
1
Connect the cable from the antenna to the Aerial In socket on the DTT. Using the
RF flylead supplied, connect the Loopthrough Out socket on the Decoder to the RF
In socket on the Decoder. This connection allows you to have access to the normal
analogue Terrestrial channels. (Refer to [1] on illustration below)
2
Using a SCART-to-SCART cable (not supplied), connect the TV SCART on the
Terminal to the SCART connector on your TV. (SCART connections only).(Refer
to [2] on illustration below)
3
If your TV set does not have a SCART connector, then use a RF flylead to
connect the RF Out socket of the Terminal to the RF In socket of your TV.(Refer
to [3] on illustration below)
4
If your TV set has a S-Video connector, connect to the S-Video connector on the
Terminal. Also connect Mono Audio on the Terminal to Audio In on the TV. (Refer
to [4] on illustration below)
5
If your TV set does not have a SCART connector, you could use a SCART-to-RCA
cable and connect the SCART connector to the TV SCART connector on the decoder
and the RCA connectors to the RCA connectors on the TV. (Refer to [5] on
illustration below.)
TV
SCART to SCART
AV Connections
A
V
RF In
S-Video
[1]
[1]
[2]
[3]
[4]
[5]
SETUP1: DTT, TV
8
