En
gli
sh
En
gli
sh
EN-48
EN-49
Operating the device
Operating the device
C
C
The results for measurements taken in a sitting and lying position may
differ slightly.
The device is designed for two users. The values for the two users are
stored separately and can also be evaluated separately.
Also, you will be given another opportunity to assign the measure-
ment to the correct user after the measurement has been taken (see
page 49).
• Before taking the measurement, check that the correct user is dis-
played.
• To change the user, press the user button for whose memory bank
you want to switch over to.
• Switch the device on using the Start/Stop but-
ton. The following display appears (Figure 1):
the heart, the measured values may be higher. If the measuring
point is higher than the heart, the measured values may be lower.
• After the device has completed its calibration
against the ambient air pressure (Figure 2),
the automatically controlled inflation process
• Now carry out the measurement.
You may also use the two user memories to evaluate measurements
taken in morning and those taken in the evening separately. To do
this, carry out the measurement in the morning using user 1 and in the
evening using user 2.
9. Selecting the user
10. Measuring blood pressure
Figure 1
Figure 2
• Shortly after the inflation procedure begins, a
check is carried out to ensure that the cuff has
not been applied too loosely. If the cuff is applied
correctly, the symbol is displayed. If the sym-
bol is not displayed by the time the pulse signal
starts, the cuff is too loose. In this case, you
should repeat the measurement after you have
applied the cuff correctly (see page 46).
• The measurement is carried out during inflation.
The symbol flashes in the display (Figure 3).
In addition, beeps denote the pulse.
starts. The cuff slowly inflates during the measurement proce-
dure.
• Inflation stops as soon as the measured values
are determined; the cuff is then automatically
deflated. A long beep denotes the end of measurement.
Figure 3
• The determined systole, diastole and pulse val-
ues, as well as the pulse pressure (PP) are shown
in the display (Figure 4).
• When the measurement is finished, you will be
given another opportunity to change the memo-
ry to which the measured value is to be saved. To
do this, press the Memory button of the user for whom the meas-
ured value is to be saved.
• The device switches itself off after approximately 3 minutes. You
can also switch the device off before this by pressing the Start/
Stop button.
Figure 4
