UDO Super Gemini — Owner’s Manual
52
LFO 1 (Low Frequency Oscillator 1)
The LFO 1 section.
An LFO, or low frequency oscillator, is an oscillator that generates
frequencies below the range of human hearing. In default mode, LFO 1
can be used to modulate the frequency of the oscillators to create vibrato
effects or to modulate the VCA level to create tremolo effects.
LFO 1 can also be set to high frequencies, allowing you to use it either as
a third oscillator, as a drone, or for audio rate modulation.
LFO 1 essentially consists of ten individual LFOs: one for each of
the ten ‘super voices’. In 20-voice non-binaural mode, each of these
ten LFOs is shared by two voices.
Modulation Parameters
RATE:
This fader controls the rate of LFO 1. The LED at the top left of the
LFO 1 section provides a visual indication of the rate.
If you enable the
SYNC
option in the arpeggiator and sequencer section,
the rate of LFO 1 will be synchronised to either the internal clock as set by
the
TEMPO
control (see page 78) or to an external MIDI clock signal (see
pages 91-92). When synchronised, you can use the
RATE
fader to adjust
the duty cycle duration of LFO 1’s waveform in clock divisions relative to
the internal or external tempo.
The following table lists the clock divider settings for the synchronised
LFO 1 rate:
Summary of Contents for SUPER GEMINI
Page 136: ......
