10
7.2 Checking
7.3 Calibration Instruction
(4). Push up the Left Stick slowly to fly up the drone,
and pull down the Left Stick slowly to the lowest
end, then the drone will land on the ground slowly.
(3). Move the Left Stick and Right Stick as Picture 7
shown to start the motor and then release.
Then push up the Left Stick to fly up the drone
to certain altitude and then release.
(5). It’s recommend to repeat Steps 4 above to practice.
(1). The camera is the drone front. Keep the drone front away from you.
(2). Power on the drone and check the direction of the rotating propellers. The left
front and right rear A propellers rotating clockwise while the right front and left
rear B propellers rotating counterclockwise.
(6). Adjust relative transmitter Trimmer button to adjust the rudder if the drone
tilts to one side when flying.
Please follow below steps to calibrate the drone if the drone becomes imbalance
after crashing during the flight, and can not be adjusted by trimmer button and
cause difficult operation.
(1). Power off the drone, then turn off the transmitter switch.
(2). Turn on the transmitter switch, push the Left Stick all the way down to the
lowest position (Picture 8) and then release. The Left Stick will back to the
middle position automatically (Picture 9). The transmitter is ready for
frequency pairing mode.
(3). Power on the drone and put it on a flat surface in a horizontal position. The
drone body lights change from flashing to solid bright, which indicates
successful frequency pairing.
Important Notice: Please make sure the drone is placed on the horizontal position
after powering on the drone, so that the drone can work well.
Picture 5
Picture 4
Picture 7
Picture 6
Picture 8
Picture 9
Summary of Contents for U42W
Page 24: ......
