udir/c Swan U42, Operation Manual

Page: 8 / 28

Propeller installation diagram
When install, put the propeller hole aims to the drone shaft hole, and then press
down until bottom, tighten it with screw, and then put on propeller cover( Pic 8);
when disassemble, loose the screw and then pull out the propeller.
Notice: When install, please make sure correct propeller in place, otherwise
the drone can not work well.
Picture 9
Picture 10
Picture 8
Warning: When pick up the motor, please don’t damage the LED board.
Motors Replacement Diagram
1. To remove the motor, remove the screw from the lampshade first
，
then take
the lampshade out, unplug the motor connector from LED board and then take
the defective motor out ( Picture 9) .
2. To install the motor, put the motor into motor holder( make sure the motor
press down and also the gears are pairing) and plug the required motor
connector into the LED board socket. Put on the motor cover and fix it with screw.
Notice: The motor’s rotating direction should be the same, or it will not work.
Tips: The motor is consumable. If it is damaged, please buy new motor for
replacement.
www.udirc.com
插好插座后，将线理顺，
按箭头方向摆放。
8