19
4. Stretch the tape and check that there is no difference in nipping force between the near side and
the far side.
○
×
×
If the tape can be stretched straight, it is OK.
If the tape is curved, it must be adjusted.
Table
Hold plate
]
5. Press the START switch to cause the main spindle to go to the initial position.
6. In the same way as above, cut the film tape about 10 to 20 cm and insert it between the tape
press-down plate (2) and the hold plate.
10 – 20 cm
Tape
7. Press the INCHING switch to move the main spindle to the position where the heater touches
the hold plate and spindle is placed one level lower from it. (Position where the heater is
lowered and the rape us held only by the tape press-down plate (2). ).
Tape
Position where the main spindle is stopped.
