UBCO 2x2 Dual-Use 2018, User Manual, Page: 23 / 57

20
1. OFF 2. ACC 3. RUN
Turning on Your 2×2
First things first, you need to turn the 2×2 on. It’s
important to remember that the 2×2 is very quiet
due to its electric drive motors, and will not rev
when it’s turned on.
The 2×2 is equipped with a three-stage key switch.
To start, insert your key into the ignition, and turn it
to ACC mode. The display will illuminate.
When in ACC mode, a green “N” will illuminate
at the top of the display; this indicates the 2×2
is in Neutral.
When the key is turned to “RUN”, the 2×2 will
beep and the “N” light will turn off. Now the 2×2
can be ridden.
Position 1: OFF
Position 2: ACC
– 12V power is on. The USB ports,
12V output, display, and horn are now active and
your high beam headlight can be turned on.
Position 3: RUN - The 2×2 can now be ridden and
the headlight and tail lights are on.
Headlight Control
Due to regulatory requirements, the headlight and
tail lights automatically come on when the 2×2 is in
“RUN” mode.
To turn off the headlight, the 2×2 must be switched
to ACC mode.
The high beam function of the headlight can be
activated in ACC mode for when temporary lighting
is required while the throttle is inactive.