1
Robotclean Accu Operating Instructions and Parts List
Tips and Hints
- The pool cleaner and filter insert should be cleaned after each use.
- The pH-value of the pool water should be between 7.0 and 7.4.
- Water temperature should be between 10°C and 32°C
Status
Indicator
Switching ON
Continuous light flashes blue
Switching OFF
Continuous light flashes red
Automatic return
Blue light flashes
Pause on reversing
Rotes light flashes
Working cycle has ended
The yellow light flashes three times and then shows constantly until the power supply is
switched off.
Low Voltage
Yellow light flashes
Water inside
Red light flashes
Pump protection mode
Blue light flashes slightly
Trouble Shooting
Fault
Cause
Solution
The pool cleaner does not work and the control
light does not flash
Function for the protection of the battery
Charge the robot
Contact the customer service
The adapter control light does not work
The adapter is damaged
Contact the customer service.
The pool cleaner does not work and the yellow
control light flashes slowly
Low battery capacity
Charge the battery
The pool cleaner does not work and the red control
light flashes slowly.
Fault in the pool cleaner
Contact the service centre
The pool cleaner does not clean in all places.
Nozzle angle incorrect
Adjust nozzle angle
Special pool shape
Adjust nozzle to enlarge cleaning angle
The water circulation of your pool is switched on
Switch off the filter pump
The pool cleaner does not work and the blue control
light flashes.
Function for the protection of the pump
Re-start the pool cleaner
MAINTENANCE
For cleaning use a commercial care product.
Do not use any cleaning products containing solvents or scouring agents, or hard sponges, brushes etc.
Cleaning the filter unit
CLEAN THE FILTER UNIT AFTER EACH CLEANING CYCLE
- Place the pool cleaner onto a level, clean surface and remove the upper housing by pressing the buttons on each side.
Einstellung 1: 0°/20° Standardeinstellung für die meisten Pools.
Einstellung 2: 0°/40° wenn der Poolreiniger das Becken nicht vollständig abdeckt.
Einstellung 3: 20°/20° für runde Becken.
Öffnen und Schließen des Gehäuses
Öffnen
Schließen
Montage der Bürste
1
Drücken Sie die Bürste in die an der
Außenseite des Gehäuseunterteiles
vorgesehenen Einkerbung
2
Stellen Sie sicher, dass die Bürste fest sitzt.
Demontage der Bürste
1
Drücken Sie die Bürste von der Innenseite
des Gehäuseunterteiles aus der Einkerbung
Manual RobotClean Accu new 1.indd 4
15.08.19 11:47