35
UAV-1001006-001
ECCN 7A994
Appendix C-1 Transponder Monitor Mode Installation Note
The Transponder Monitor mode is the simplest and most common installation
configuration for the echoUAT. Squawk and Barometric altitude are decoded from the
Transponder interrogation replies through the aircraft electrical system and there are no
connections required between the transponder and the echoUAT.
The echoUAT is supplied power, ground and GPS data via the Molex connector. The
unit is configured via Wi-Fi with a mobile device and outputs ADS-B
‘IN” data via the Wi-
Fi to a mobile device hosting an EFB application. In this configuration, Pin 5 of the
Molex connector outputs ADS-B
“IN” signals for connection to an MFD or EFIS in GDL
format.
Setup
Source
Control
Source
GPS
Source
Traffic
COM1
Rate
COM1
Data
COM1
Phy
Com 1
Protocol
Com 2
Rate
COM2
Protocol
APP
Transponder
Monitor
External
COM2
MFD
COM2
N/A
N/A
N/A
N/A
115200
NMEA
Summary of Contents for echoUAT
