UAS SMOGHOG SHM-C Series, Owner'S Manual

Page: 9 / 36

reV: 16i
SMoGHoG
®
SHM Series Models
5
3.4 MECHANICAL INSTALLATION
CRUSH HAZARD
use adequate safety measures when lifting and
assembling any heavy components. consult your
plant safety personnel for recommendations.
connect lifting slings and spreader bars to lifting lugs
with clevis pins. use spreader bars to distribute the
load evenly. Location must be clear of all obstructions,
such as utility lines or roof overhangs.
When the SHM unit is to be mounted directly to a
machine , you will be furnished with a mounting flange and
drawing to illustrate the bolt pattern and hardware required
for proper mounting to their equipment. Be sure to seal
around the entire perimeter between the mounting flange
and the existing machine with an appropriate sealant in a
figure-eight pattern around each bolt hole.
units with
sumps utilize 10˝ inlets and optional collar
flange(s) that come mounted to the unit. they can be
rearranged and mounted however desired based on
application needs. Be sure to use a polyurethane sealant
or gasket to prevent leaks. it is recommended to use
ducting that is liquid tight to prevent leaks.
all other transitions, ducting or plenums required for
unit set-up and operation are not included with the
equipment.
unit should always be secured to the floor when
installed in this configuration.
Secure the unit at all four corners using the standard
unit feet or extension leg foot pads. At least one of the
two holes per foot pad on the extension legs should be
secured. See figure 1 for reference.
Ceiling mounted units are suspended by means of 1⁄2˝
threaded rods (item #1 in figure 3) which run through
weld nuts (item #2 in figure 3) in the top corners of the
units. refer to figure 2 for weld nut locations on SHM-11
models. Additional support should be used for auxiliary
equipment or ducting. do not suspend units larger than
the SHM-11 from the ceiling.
CAUTION
the SMoGHoG should not be used for support of
personnel or material. check with local building code/
structural engineer to ensure proper installation to roof
truss or any other mounting method.
Metal Truss Supported Ceilings. figure 3 shows an
SHM-11 unit suspended from a metal truss supported
ceiling. customer should take care to determine that the
truss will be sufficient to support the weight. as shown,
angle iron braces are secured between two steel trusses.
rod length should be kept to a minimum and cut to length
as necessary.
FIGURE 3
Ceiling Mounted Unit
in this instance, the rods instead will be installed in the
exact same fashion into the weld nuts found in the blower
cabinet.
Be sure rods are threaded adequately into weld nuts,
about 1˝ (25.4 mm) of rod extending inside the cabinet is
acceptable.
tighten lock nuts (item #3 in figure 3) in place to be sure
unit does not vibrate lose or fall over time.
!
D A N G E R
CAUTION