reV: 16i
SMoGHoG
®
SHM Series Models
16
5.2.1 INSTALLATION PROCEDURE FOR
PEACH
®
SATURATED DEPTH FILTER
ELEMENTS
inspect filters to verify there is no damage and all packing
materials have been removed. a supportive piece of foam
may be inside the filter tube and should be removed
before operation. Be careful upon removal not to pull too
aggressively to dislodge the inner-most end cap.
Set the header plate (balloon #3 in figure 5a) on the floor
and place a cartridge in the center of each hole. Lift the
header plate up until the top flange of each cartridge rests
on the plate. Slide the filter assembly onto the cam-bar
and into the cabinet while the cam-bar is in the lowered
position (balloon #4 in figure 5a) (both handles down)
until the filter bottoms out on a stop. once the entire
cassette is inserted into the cabinet verify that each filter is
sitting straight and fully seated in each header plate hole.
rotate the cam-bars upward as illustrated in balloon #5 to
push the filter up and seal it against the tube sheet.
5.2.2 INSTALLATION PROCEDURE FOR
PRE-FILTER & BAG FILTER
the pre-filter and primary bag filter must be slid into and
out of their respective tracks in a delicate and uniform
fashion to avoid damage to the filter or jamming inside
the tracks.
Be sure the bag filter is slid into place prior to hanging the
individual bags/loops.
for units that are two filters deep, be sure to push the first
filter all way toward the back of the primary filter cabinet
until it contacts the stop. reference balloon #1 in figure
5a.
the hanging rod is to be inserted through each filter loop
and hung from a bracket on each side of the primary filter
cabinet. Work from the back of the cabinet toward the
front.
center the filter on each rod, and each rod on its
respective bracket.
Verify all bags are hung and supported properly before
securely closing and locking each door/latch. reference
balloon #2 in figure 5a.
5.3 CONTAMINANT REMOVAL
drain the sump regularly. the required frequency of this
action will be dictated by the load rate and operation.
Be sure oil is not accumulating in any location that could
cause malfunction or a safety concern including, but not
limited to, the motor cabinet, filter header plate, and tube
sheet panel.
Be sure to dispose of, or recycle, any waste oil properly.
dispose of waste in accordance with applicable local,
state, and federal regulations.
Filter Type
Part #
SHM-11
SHM-12
SHM-21
SHM-31
SHM-22
SHM-32
Aluminum Mesh Pre-filter
33-10117
1
2
2
3
4
6
Coalescing Primary Filter
33-10128
4
8
8
12
16
24
Fiberglass Bag Primary Filter
33-0221
1
2
2
3
4
6
95% O/M A�er-filter
33-10129
1
2
2
2
4
6
95% O/M for Enclosed Cabinet
33-10131
1
2
2
2
4
6
HEPA A�er-filter
33-10082-0002
1
2
2
2
4
6
HEPA for Enclosed Cabinet
33-10132
1
2
2
2
4
6
Replacement Filter Quan��es
Summary of Contents for SMOGHOG SHM-C Series
