Intelligent High Speed Dome Camera Address Setup
Before the application of high speed pan/tilt dome, the address code should be setup firstly. The add-
ress code is decided by the 8 bits dip switch on back panel which adopted with 8421 code. Support up to
255 pieces addresses. ON is respected by number 1. OFF is respected by number 0. Please check the atta-
ched address list at the back side of manual for the detailed setting way (Refer Chapter 10: Address code
DIP diagram) .
Notice
Factory default address code is 1.
Please make sure dip switch is on position, otherwise,the dome
camera will out of control.
Please make sure the dome can be controlled before installation.
The method of address code setup
Serial No.
Address Code
Dip switch has defined address number for each bit, as above diagram: No.1 stands for 1 address No.,
No.2 stands for 2 address No., No. 3 stands for 4 address No., and No. 4 stands for 8 address No.
,
how many channels you would like to set, just dip the relevant serial number to
You can plus exi-
sting address bits., to get what you can not find from the dip switch diagram.
I.e. If you want to dip the 1 address No, just dip serial No. 1 to
If you want No.37 address, just
dip No.1, No.4, No.32 to
position
st
nd
th
th
st
¡
“on”.
“ON”.
“ON”
.
1 Channel
37 Channels
7
Protocol & Address Code Setting
u
Camera module setup:
ON/OFF
ZM0
(Pin 4)
ZM1
(Pin 5)
CAMERA
OFF
OFF
SONY
ON
OFF
YOKO
OFF
ON
CNB
ON
ON
LG
1. NTSC/PAL setup:
NT/PAL
(Pin 6)
NTSC/PAL
OFF
NTSC
ON
PAL
