33
33
You are ready for finish!
Main Objective:
Remove the tape, attach the bridge, ream the bridge pin holes and fit the
saddle.
Step Twenty Four – Attaching the Bridge
•
The tape used to preserve the bare wood
underneath is completely encased in finish.
•
Using a utility knife, cut through the finish and
remove the tape where the holes are for the
bridge clamp studs.
•
Using the clamps again, place the studs through
the clamp, through the bridge and onto the top.
•
Either completely clamp it down or hold it
securely while you firmly and carefully cut
around the perimeter of the bridge and through
the finish only….not the top.
•
Be sure to remove any stray blue tape and
ensure the surface is completely bare wood
only.
•
Apply acetone to a rag and wipe the back of the bridge to clean it and
remove any natural oils. Let it dry for a few minutes.
•
Apply glue to back of bridge and use the
bridge clamp to locate the bridge and
tighten the wing-nuts and thumb screws
securely.