SAFETY •
INSTALLATION & INTEGRATION
• OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
USER GUIDE
u-line.com
Product Dimensions 1
Side-by-Side Installation
Two units may be installed side-by-side.
Cutout width for a side-by-side installation is the
cutout dimension of a single unit times two.
No trim kit is required. However, 1/4" (6 mm) of
space needs to be maintained between the units to
ensure unobstructed door swing.
Units must operate from separate, properly grounded
electrical receptacles placed according to each unit’s
electrical specifications requirements.
Side-by-Side Installation with Bracket
1.
Slide both units out so screws on top of units are
easily accessible.
2.
Remove screws as shown below.
3.
Place bracket over holes and attach to unit with
two screws removed in step 2 using a T-25 Torx
driver.
Tighten screws fully.
4.
Gently push units into position. Be careful not to
entangle the electrical cord or water line, if
applicable.
5.
Re-check the leveling, from front to back and side
to side. Make any necessary adjustments. The
unit’s top surf
ace should be approximately 1/8" (3
mm) below the countertop.
Side-by-Side Installation 1
