58
TWITE INSTRUMENTS
THERMOSTAT MODEL TD-196 OPERATING MANUAL
REMOTE DISPLAY MODULE CONT.
S
ETTING
F
UNCTIONS
C
ONT
.
4.
SCAN CHANNELS YES OR NO
Sets whether the remote display will scan or not for each TD-196 channel for each
unit that is connected via the RS485 serial line.
NOTE :-
If the remote display is set to scan/display a TD-196 units channel
that is not connected to the serial line, it will time out after approximately 1 minute
and not display/scan that units channel but will not alter the set point. This means
that if a TD-196 unit is then connected to the serial line the remote display will
automatically pick up the information and proceed to display/scan this TD-196 unit
channels. If a TD-196 unit is connected to the serial line and the remote display is
set to not display/scan this unit channels, it will not.
PRESS “
SET
”
PRESS
s t
TO SELECT NUMBER
4
PRESS “
ENT
”
s
TO SELECT UNIT NUMBER
(1 TO 16).
"SET"
TO SELECT CHANNEL NUMBER
(1 TO 8).
t
TO SELECT "YES" OR "no" ON LED FOR THE CHANNEL
NUMBER OF THE
DISPLAYED UNIT.
PRESS “
ENT
”
SELECTION COMPLETE
5.
DISPLAY INTENSITY.
Sets the brightness of the display from 0 - 15 inclusive.
PRESS “
SET
”
PRESS
s t
TO SELECT NUMBER
5
PRESS “
ENT
”
s t
TO SELECT REQUIRED BRIGHTNESS ON LED
(8 recommended)
.
PRESS “
ENT
”
SELECTION COMPLETE.
