Rev: 2015.04.22.v03a
page 9
Locate the Side Force Generator Tree
and free all the parts from each other
While waiting for the Welders to tack
up, clean out the small scrap from the
cut out near the end of the wing as
shown
Once free from one another, remove all
the little tabs so that the edges are
smooth
In the center of the rear of each SFG,
split the foam as shown
This slit will be used later to install the
SFG onto the wing... repeat this with
the other three pieces
By now the Welders should be tacked
up. Carefully bring the pieces together
making sure that alignment is
maintained. With the tack up method,
you have to get it right the rst time.
