Rev: 2015.04.22.v03a
page 17
2.00"
Once the glue has tacked up, assemble
the two pieces. Use the slot on the
rudder to line up with the n on the
fuselage
Next up are the fuselage trusses. To
install these, apply a medium bead of
Welder’s to the beveled areas. Do one
at a time, keep an area of one free of
glue as shown two steps down
Do the truss for the electronics side
next, keep the area shown free of glue
for now, this will help to provide an
area to tuck the wires into later on.
Apply Welder’s to the mating surface of
the aircraft and allow to tack up.
Locate the motor mount, rough up one
side with sand paper or the edge of a
le and apply an even medium coat of
Welder’s to the roughed up side.
While the glue is fresh and wet, bring
the pieces together. Apply a little
pressure along the glue joint a couple
times to ensure a solid bond. Repeat for
the other side.
