Rev: 2015.04.22.v03a
page 7
A quick link will be glued to the end of
the 4 control rods. Hold the rod with
your ngers....
.... dunk it approx 1/2” into the nozzle
of the Welders tube as shown and twist
a time or two
Pull the rod out and check that you
have a nice, even coat of glue as shown,
if not, repeat the process
Multiple power combos are available
through Twisted Hobbys. Each will
operate the model per recommended
spec’s, different components vary and
are shown in the manual.
Multiple power combos are available
through Twisted Hobbys. Each will
operate the model per recommended
spec’s, different components vary and
are shown in the manual.
Attach a snap link as shown. Notice
that the snap link has a “saddled” area,
this should be where you rest the
control rod, repeat for the other rods
and set aside to dry for 24 hours
