INSTALLATION · ASSEMBLY AND ELECTRICAL HARNESS
Use the long screws removed from the windshield
frame and insert them through the top windshield
frame holes into the lower radio mounting holes(g)
and finger tighten.
Tighten all screws with the Torx wrench. Finally, (h)
insert and tighten the center windshield frame screw.
Next, you must install the wiring harness supplied
with your audio system (i). First you must remove
the seat and completely disconnect the battery.
On these motorcycle models you need to lift the
gas tank up to install the harness underneath, along
the frame. Start by removing the hardware that
holds the tank, the long bolt at the front of the
tank (j) and the screw at the rear of the tank (k).
5
STAGE THREE: INSTALL RADIO ELECTRIC HARNESS
Once released you can lift the tank (l) and block it up an
inch or two using anything handy, such as a screwdriver (m).
g
g
h
i
j
l
k
m
k
m
j
