Inserting a Battery
15
14
Preparing for Use –Thick Tube
1
Lift the notch at the edge of
the battery compartment
and swivel open the door of
the battery compartment.
2
Remove the brown-colored
tab on a new battery (size
312). Wait two (2) FULL
minutes for battery to fully
activate.
Insert the battery
with the
positive “
+
” side
facing up
.
Notice the “+” on the edge
of the battery door to
assist you in finding the
proper orientation.
Inserting a Battery
ON
–When the battery door is completely closed, your TweakConnect is on.
OFF
– To turn off your TweakConnect, open the battery door part way.
3
Gently close the battery door. It should close
easily; do not force the door closed.
If resistance is experienced while closing the battery
door, make sure the battery is inserted properly.
When the battery door is completely closed, your
TweakConnect is ready for operation.
Preparing for Use –Thick Tube
continued
Trimming the Sound Tube
Remove the amplifer and tube
from your ear and cut the tube
0.2” (3mm) above the mark on
the tube. To assemble simply
slide the tube over the end of
the earhook.
Cut here
Connecting Sound Tube to the Earhook
Attach the tube to the earhook
by pushing the open end of the
tube onto the small end of the
earhook until tight.
Attaching a Dome to the Sound Tube
Choose a dome from the
accessories then attach it to the
thick tube by pushing it straight
onto the tube until snug.
Instructional videos can be found in the TweakConnect Support
section of TweakHearing.com
