twall Premium64, User Manual

Page: 19 / 40

t wall
®
Premium64 standard Color mobile / stationary User manual | Rev. 1.0.3
E| 19
fig. 3.2-6
Step
3
Insert a long frame profile
A2c
into the lower lead channel (towards the floor)
between the side supports
A2a
.
The ends of the frame profile and the side
supports have to be on the same level and
need to be flush-mounted
(fig. 3.2-5)
. The
cross pieces of the profile connectors should
point upwards (towards you). Now tighten
the profile connectors with the corresponding
Allen key (ca. 25Nm).
Step
4
Shove the shield
A2b
into the
lower lead channel between the side supports.
The shield (8 mm | 0.32 inch) should click
exactly into the lead channel of the long frame
profiles
A2c
which you have just assembled.
Step
5
Then insert another long frame
profile
A2c
into the lower lead channel
between the side supports and move it
towards the shield which should click exactly
into the lead channel of the frame profile
(fig. 3.2-6)
.
The cross pieces of the profile connectors
should point upwards (towards you). Please
tighten the profile connectors (ca. 25Nm).
II. Attaching the profile angles to the
frame profiles:
Step
6
In order to attach the profile
angles
A2e
, you will need sixteen (16) fillister
head screws with flange
M6x14
(2 per angle)
and sixteen (16) T-nuts
M6.
. Measure the
long frame profile
A2c
which you have just
mounted to the shield. There are
930 mm
| 36.61 inch
from to inner edge of the side
supports to the middle of the screws the
profile angles will be screwed on with. Now
place two (2) T-nuts in the lateral lead channel
of the long frame profile (the shield just
clicked into the lead channel at the other side
of the frame profile). Insert the T-nuts by half-
twisting them into the lead channels with the
swivel ball ahead and align them appropriately
(fig. 3.2-7).
Now insert two (2) T-nuts into the lead
channels of the short frame profile
A2d
, 1 x
at the bottom left and 1 x at the bottom right.
There are 967 mm | 38.07 inch from the inner
edge of the side supports to the middle of the
lead channel.
Place the short frame profile
A2d
in the
middle of the long frame profile
A2c
and
attach the profile angles
A2e
A2e, one to
each side using the fillister head screws with
flange
(fig. 3.2-8)
. Tighten it properly with
the corresponding Allen key.
fig. 3.2-7
fig. 3.2-5
T-nut
fig. 3.2-8
angles
930 mm
967 mm
cover