twall Premium64, User Manual

Page: 14 / 40

t
wall ® Premium64 standard Color mobile / stationary User manual | Rev. 1.0.3
14 |E
930 mm | 36.61 inch
from the inner edge
of the side supports to the middle of the
screws the profile angles will be screwed on
with. Attach two (2) profile angles
A2e
to the
long and the short frame profiles again
(fig.
3.1-22 and fig. 3.1-23)
. Afterwards tighten
the profile connectors of the long frame
profile
A2c
with a corresponding Allen key
(ca. 25Nm).
Please pay attention to a horizontal alignment
of the frame profile so that a correct
placement of the basic modules is ensured
(spirit level).
Step
16
Please go back to step
14
and
step
15
and repeat the procedure with the
remaining frame profiles
A2c
and
A2d
.
III. Fastening the angles braces:
Now you need to attach the angles braces
A1g
to the rear part of the frame base
A1
and the rear side of the side supports
A2a
(fig. 3.1-24)
.
Step
17
Place a T-nut into the lead
channels at each side of the frame base
profiles
A1c
. Put two (2) adjusting blocks
opposite of each other into the provided holes
of the joints.
This time it is very important to insert the
adjusting blocks into the holes at the open
sides of the joints (not the sides where the
arms are located)
(fig. 3.1-25)
. The number
8 on top of the adjusting blocks have to point
outwards again
(fig. 3.1-26)
.
They will fit exactly into the lead channels.
Now position the joints at the frame base
profiles
A1c
. and bolt them together using
two (2) socket head screws
M8x16,
two (2)
washers and the corresponding Allen key.
To make the assembly a bit easier for you, we
would advise to place the other ends of the
angle braces backwards.
Step
18
In order to fit the other ends of
the angles braces
A1g
to the side supports
(fig. 3.1-27)
you need to insert two (2) T-nuts
M8
into the lead channels at the rear side
of the side supports (one Tnut per side) and
position the adjusting blocks, as described
above, in the remaining holes of the joints.
Now bolt the joints at the angles braces to the
side supports using the remaining socket head
screws
M8x16
and the washers and tighten
them properly.
fig. 3.1-27
fig. 3.1-24
frame base
angle brace
joint
fig. 3.1-25 fig. 3.1-26
open side of
the joints
fig. 3.1-23